Updated November 2026 by Wolf River Electric.
Standing seam metal roofs: no penetrations
Standing seam roofs have raised vertical seams every 12 to 24 inches. Clamps made for the exact seam profile tighten onto the seam with set screws, and the solar rails or panels attach to the clamps. Clamp makers such as S-5! design their clamps to grip the seam without piercing the roof panels or damaging the coating, which helps keep the roofing manufacturer’s warranty intact. Because nothing goes through the roof, there is nothing to seal and nothing to leak.
We match the clamp to your roof profile and confirm the seam spacing and attachment strength for Midwest snow and wind loads during design.

Corrugated and exposed-fastener metal roofs
Many farm buildings, cabins and newer homes have exposed-fastener metal, often called R-panel, ag panel or corrugated metal. These roofs have no seams to clamp, so the mounts attach to the raised ribs or to the purlins underneath with gasketed, sealed fasteners. Done right, the attachment is as weathertight as the screws already holding the roof down. Pole barns and shops with exposed-fastener roofs are common sites for larger systems; see ground-mounted solar if the roof structure is not a good fit.

Why metal and solar work well together
- Long life: a well-installed metal roof typically lasts decades longer than an asphalt shingle roof, so the roof is likely to outlast or match the life of the panels, which carry 25-year warranties.
- Fewer or no roof holes: clamp mounting on standing seam needs no penetrations.
- Snow sheds well: snow slides off smooth metal panels and the solar panels, so the system gets back to producing sooner after a storm.
- Cooler panels: the air gap between the panels and the roof helps them run cooler, and solar panels make more power when they are cooler.

Plan for snow sliding off
Metal roofs already shed snow fast, and snow slides off the glass of solar panels even faster. That is good for production, but a sheet of snow coming off the roof can damage gutters, landscaping or anything below the eave, and it can be a hazard over doors and walkways. We place panels with this in mind and can add snow guards below the array where snow would land on a door, deck, driveway or lower roof. Snow guards on standing seam roofs use the same no-penetration clamps. Read more about snow on solar panels.

Metal roof and solar questions
Will mounting solar void my metal roof warranty?
Seam clamps are designed to protect the seam and its coating, and many roofing warranties allow them. We check your roofing warranty terms before we design.
Is solar on a metal roof more expensive?
Usually not. Standing seam clamps often install faster than flashed mounts on shingles. Exposed-fastener roofs can need more attachment points, which we price in the quote.
Can you install on a metal roof over shingles?
Often, yes, if the roof structure is sound. We check the framing during the site visit.
What about a new metal roof?
If you are getting a new roof, put it on before solar. Wolf River Electric does not install roofs, but we work around your roofer’s schedule. See re-roofing with solar panels and how to prepare your roof for solar.
Get a solar design for your metal roof
Send us a few photos of the roof and a year of electric bills, and we will design the system and mounting for your roof type. Get a free solar quote.
Sources: S-5! roof clamp product information (2026); Wolf River Electric installation practice.
Free quote
See what solar and backup power can save you
Get a custom design and savings estimate from Wolf River Electric. No cost, no obligation.